Visara VI-5990 - Manual (Page 19)

VI-5990 Installation and Configuration Manual
707166-001 1-13
Powering Up the VI-5990
If you are applying an IP address, insert the USB drive into one of the USB sockets
before applying power. With both power cables attached to the VI-5990 and a power
source, press the power button (button is located in the upper right corner of the front of
the platform) to apply power.
VI-5990A Front View
Power Button
VI-5990L Front View
Power Button
Note, if only one of the power cables is attached you should get a power supply error and
an audible alarm. If none of the indicators light up with the power applied, recheck the
power cable connections and check any power switches or circuit breakers associated
with your power source.
Once the power up sequence has completed (should take less than 5 minutes), you should
be ready to configure the VI-5990 with your browser or through the local console.