Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 80)

3-50 W A N s u i t e 7 2 0 5
Test Details Screens
The Test Details screens let you set some test parameters and view other read-
only parameters. This screen is also used to initiate a BERT or Loop Test.
The Network Interface Test Details screen is shown in Figure 3.40, and its
parameters are described below the figure. The Serial Interface Test Details
screen is shown in Figure 3.41, followed by a description of its parameters.
Figure 3.40 Network Interface Test Details Screen
BERT Table on the Network Interface Test Details Screen
The BERT table lets you set the parameters listed below.
Setting Displays the bandwidth on which you wish to perform the BERT. The
available values for this parameter depend on which interface you select.
Values: Idle, Channel 1...31, Net, Use Service
Default: Net
Service Selects the channels with a service to BERT (see Services Screen on
page 3-17).
Channel Rate Sets the bit rate to BERT for each selected channel. If “Nx64K” is selected,
the ones density requirements of the E1 network line must be ensured. If
“Nx56K” is selected, ones density for the selected DS0 channel is maintained.
Values: Nx56K, Nx64K
Default: Nx64K
NOTICE: The Service and Channel Rate parameters will appear only on Network
screens.