Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 169)

V T 1 0 0 I n t e r f a c e 4-47
Figure 4.40 Diagnostics Screen
The Diagnostics screen contains the fields described below.
Test Details Screens
The Test Details screens let you set some test parameters and view other read-
only parameters. These screens are also used to initiate a BERTs or Loop
Tests. The Network Interface Test Details screen is shown in Figure 4.41, and
its parameters are described below the figure. The Serial Interface Test Details
screen is shown in Figure 4.42, followed by a description of its parameters.
Field Description
Description Describes the type of interface selected for testing.
Loop Type Describes the type of loop test (if any) performed on the selected
interface.
Setting Displays the bandwidth on which you wish to perform the BERT.
Pattern Specifies the pattern to be transmitted during a BERT for the
selected port.
Length Displays the length of time for which the BERT should run for the
selected interface.
State Displays the current BERT state for the selected interface.