Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 102)

3-72 W A N s u i t e 7 2 0 5
ICMP Timer The maximum time (in seconds) NAT will use resources for any ICMP
request.
Values: 0
−
65535
Default: 120
The NAT Details screen provides the following user-activated buttons:
Static TCP Translation Table Screen
The Static TCP Translation Table screen (Figure 3.61) allows static mapping
of global TCP Server ports to a local host IP address/port combination. The
parameters described below enable access to TCP servers on the private/
corporate network “behind the NAT.” The parameters may be used only when
in NAPT mode.
Figure 3.61 Static TCP Translation Table Screen
Global Port Decimal IP Port exposed to the global Internet. Default is 0.
Server Port Decimal IP Port of the local TCP Server. This port is usually the same as the
Global Port. Default is 0.
Server Address IP Address of the local TCP Server. Default is 0.0.0.0.
The Static TCP Translation Table screen provides the following user-activated
buttons:
Button Function
Submit Sets any values that have been changed.
Static TCP Translation Table Allows static mapping of global TCP Server ports to
a local host IP address/port combination.
Static UDP Translation Table Allows static mapping of global UDP Server ports to
a local host IP address/port combination.
NAT Port Table Defines NAT global/Internet and local/corporate
ports.
Refresh Refreshes data on the current page.
Button Function
NAT Details Returns the user to the previous screen.