Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 77)

W e b S e r v e r I n t e r f a c e 3-47
Filter By IP Port Enables or disables filtering of the IP traffic by the IP port specified in the IP
Port field.
Tx Alarm Threshold Specifies the threshold in bits per second for the Transmit Alarm on this rule.
Tx Alarm Shows the current Transmit Alarm status.
Traffic Meter Statistics Screen
The Traffic Meter Statistics screen displays the number of frames and octets
sent over a DLCI that have been counted in accordance with the Service
Aware “rule” that has been established for a Service. As such, it is frame
relay specific (i.e., DLCIs only occur in frame relay links). In addition, this
screen provides data rate performance information for the period of time you
have specified in the Period Index field (see below).
Figure 3.37 Traffic Meter Statistics Screen
The Traffic Meter Statistics screen reports on the following parameters:
• Tx Frames
• Tx Octets
• Rx Frames
•
Rx Octets
•
Rate Peak – the peak data rate for the viewed period (see below)
•
Rate Average – the average data rate for the viewed period (see below)
The Period Index field is used to define the period of time for which the
Traffic Meter statistics will be reported. It represents the 24-hour, 15-minute
buckets index. Selecting a period and then clicking the “Submit” button will
display the traffic meter statistics for that period. Clicking on the “All Traffic
Meter Intervals” at the bottom of the screen displays the Traffic Meter
Statistics for all intervals as defined below.