Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 76)

3-46 W A N s u i t e 7 2 0 5
Figure 3.36 Rule Config Screen
The paragraphs below describe the rule configuration parameters and their
options.
Service Selects the service to which the rule applies. Select from a pull-down list of
available services.
NOTICE: If you change a Service parameter, you must click on “Submit” to see
the appropriate DLCIs.
DLCI Selects the DLCI to which the rule applies. Select from a pull-down menu
that lists applicable DLCIs.
Filter By DLCI Enables or disables filtering of the IP traffic by the DLCI specified in the
DLCI pull-down list.
NOTICE: To use this filter, you must specify both the Service and DLCI
parameters in the rule configuration.
IP Address Establishes the IP address by which the rule will filter IP traffic (if enabled).
IP Mask Represents a range of IP addresses defined so that only machines with IP
addresses within that range are allowed to access an Internet service. To mask
a portion of the IP address, replace it with the wild card character “0” (zero).
(For example, 192.44.0.0 represents every computer on the Internet with an IP
address beginning with 192.44.)
Filter By IP Address Enables or disables filtering of the IP traffic by the IP address specified in the
IP Address or IP Mask field.
IP Port Establishes the IP port by which the rule will filter IP traffic (if enabled).