Verilink WANsuite 7205 (34-00317.B) Product Manual - Manual (Page 144)

4-22 W A N s u i t e 7 2 0 5
A “Clear History” prompt is also included on the 24 Hour and 30 Day History
screens.
Frame Relay Service Details Screen
Access the Frame Relay Service Details screen (Figure 4.19) by selecting
“Frame Relay” under the column on the Service Table screen.
Figure 4.19 Frame Relay Service Details Screen
The Frame Relay Service Details screen displays Service, Pair, and Interface
details across the top of the screen. Fields shown at the top of the Frame
Relay Service Details screen are listed below.
Screen parameters that can be viewed and/or changed are listed below. To
save new parameters, press the “Esc” key.
Interface Type If this service is connected to a Frame Relay network, the Interface Type
should be set to “UNI” as it is the user side of a user-to-Network interface. If
it is connected to a FRAD/router, the Interface Type should be set to “NI” as
it is the network side of a user-to-Network interface. If it is connected to an
equipment set for Network-to-Network interface, the Interface Type should be
set to “NNI.”
Values: UNI, NI, NNI
Default: UNI if interface is Network, NI if interface is Serial
Field Description
Active Read-only status (No, Yes)
LMI Type Read-only status
FrameStart Status Read-only status
Round Trip Delay (bytes) Specifies the frame size (in bytes) of packets making
round-trip.
Round Trip Rate (sec) Specifies the rate (in seconds) at which round-trip
packets are sent.