Teac DP-006 - Manual (Page 67)

TASCAM DP-006
67
8 – Editing Tracks
Editing on a conventional tape recorder in the past required advanced
techniques, but with this unit editing tracks is easy and accurate. Moreover,
with a tape recorder, an editing error could not be undone, but this unit uses
nondestructive editing, allowing you to edit without altering the original data.
This means that the undo function can be used to correct an edit easily. (See
“Undoing operations (undo)” on page 58.)
Overview of track editing
This unit has the following track editing functions.
•
CLONE TRACK (duplicate a track)
•
CLEAN OUT (erase a track)
•
SILENCE (erase part of a track)
•
CUT (remove part of a track)
•
OPEN (insert a silent section)
Editing points
Among track editing functions, SILENCE, CUT and OPEN use the IN and OUT
points for editing. These are the same as the IN and OUT points used for repeat
playback.
For instructions about how to set IN and OUT points, see “Setting IN and OUT
points” on page 65.
Use the I/O SETTING screen to edit IN and OUT points. (See “Setting IN
and OUT points” on page 65.)
IN point
The IN point is the beginning of the part of the track that will be edited.
Press the IN/OUT button to open the I/O SETTING screen, and press the
F3 [IN] button at the time where you want to set the IN point.
OUT point
The OUT point is the end of the part of the track that will be edited.
Press the IN/OUT button to open the I/O SETTING screen, and press the
F4 [OUT] button at the time where you want to set the OUT point.
Basic editing procedures
1. When the recorder is stopped, press the MENU button to open the
MENU screen.
2. Use the DATA wheel to select (highlight) the TRACK EDIT item, and
press the F4 [t] button to open the TRACK EDIT screen.