Teac DP-006 - Manual (Page 66)

66
TASCAM DP-006
7 – Recorder Functions
3. When finished editing, press the HOME button to return to the Home
Screen.
Using repeat playback
1. Set the starting (IN) and ending (OUT) points for the time that you want
to repeat, and then return to the Home Screen.
2. Press the REPEAT button to start repeat playback.
The icon appears on the Home Screen during repeat playback.
Repeat icon
Playback starts from the IN point. When the OUT point is reached, after
the set repeat interval elapses, playback starts again from the IN point.
Playback continues to repeat between the IN and OUT points.
3. Press the REPEAT button again to stop repeat playback. The icon on
the Home Screen disappears.
The next section explains how to set the repeat interval that determines
the amount of time until playback starts again after the OUT point is
reached.
NOTE
If the time between the IN and OUT points is less than 2 frames, an I/
O Too Short
pop-up message appears when you press the REPEAT
button and repeat playback will not occur.
Setting the time between repetitions (repeat
interval)
The time between repetitions (repeat interval) can be set from 0.5 to 9.9
seconds.
1. Press the MENU button to open the MENU screen.
2. Use the DATA wheel to select (highlight) the PREFERENCE menu item,
and press the F4 [t] button to open the PREFERENCE screen.
3. Use the F3 [5] and F4 [b] buttons to select (highlight) the Repeat
Int item setting value, and use the DATA wheel to set the value
between 0.5sec (default value) and 9.9sec (in 0.1-second incre-
ments).
Use the F3 [5] and F4 [b] buttons to select (highlight) the Repeat
Int
item setting value, and use the DATA wheel to set the value
between 0.5sec and 9.9sec (in 0.1-second increments).
4. After making the setting, press the HOME button to return to the Home
Screen.