Teac DP-006 - Manual (Page 32)

32
TASCAM DP-006
3 – Names and functions of parts
Rear panel
g INPUT B ( standard jack)
Use this jack for a line level or mic signal (unbalanced connection).
Use this as an input source by setting IN-B (INPUT B) on the INPUT
SETTING
screen for a line level input (LINE, LINE Mid or LINE
High ) or an external mic (MIC).
h INPUT A ( standard jack)
Use this jack for a guitar, line level or mic signal (unbalanced connection).
Use this as an input source by setting IN-A (INPUT A) on the INPUT
SETTING
screen for a guitar or line level input (GUITAR/LINE,
GUITAR/LINE M or GUITAR/LINE H) or an external mic (MIC).
Set the MIC/LINE-GUITAR switch on the left side of the unit according to
the input source.
Left side panel
j MIC/LINE-GUITAR switch
Set this switch to match the input signal to the INPUT A jack on the rear
panel. For mic or line signals, set it to MIC/LINE. For electric guitars and
basses that are connected directly, set it to GUITAR.
TIP
When connecting an electric-acoustic guitar with a built-in preamp or an
active electric guitar, as well as when connecting an electric guitar with
effect boxes between it and this unit, set the MIC/LINE-GUITAR switch to
MIC/LINE.
k /LINE OUT jack (stereo mini jack)
Connect headphones or an external monitoring system (powered monitor
speakers or an amplifier and speakers) here.
l The VOLUME dial
Use to adjust the volume output from the /LINE OUT jack.
CAUTION
The VOLUME dial does not have any indications. Before turning the power
ON, always turn it in the direction of the arrow until it stops to minimize
the volume. Sudden bursts of loud sounds can cause hearing damage and
speaker damage, for example.