Teac DP-006 - Manual (Page 60)

60
TASCAM DP-006
6 – Basic Recording
Erasing the operation history
When the power is turned OFF(in standby), the operation history of the
currently loaded song is erased (cleared). The operation history is not restored,
so past operations cannot be undone or redone when the power is turned ON
again.
You can also erase the operation history of the currently loaded song without
turning the power OFF by using the following procedures.
NOTE
Turning the power OFF (putting it in standby) does not erase the operation
history of songs that are not loaded.
1. While pressing and holding the Stop (8) button, press the UN/REDO
button to open the HISTORY screen.
2. Press the F4 [CLEAR] button.
A confirmation pop-up message appears.
3. Press the F3 [YES] button.
Another confirmation pop-up message appears.
4. Press the F3 [YES] button to erase the operation history and delete
unused data.
The Home Screen reopens when this operation completes.
NOTE
To cancel erasing the operation history, press the F4 [NO] button.
TIP
•
If you open the HISTORY screen immediately after erasing the operation
history, the event (operation) that appears is 0 (-START UP-), showing
that the operation history has been cleared.
•
If you want to keep the operation history even when you power OFF(in
standby), turn song protect ON before turning the power OFF(in standby).
(See “Protecting songs” on page 50.)
CAUTION
You cannot undo erasing the operation history! Only do it if you are certain
about it.