Teac DR-40 - Manual (Page 93)

TASCAM DR-40
93
When
MIX
is selected, you can set the level (SEND) of each
signal sent to the effect on the
MIXER
screen. (See “Mixer”
on page 94.)
4 Use the + or – button to select the desired item and
press the ENTER/MARK button or
/
button to access
that item’s settings.
5 Use the + or – button to set the desired value.
6 Press the . button when you are done making the
setting to return to item selection status.
7 Press the (HOME) [8] button to return to the Home
Screen.
NOTE
When the sampling frequency is set to 96 kHz, or a WAV file
with a sampling frequency of 96 kHz is played, the built-in
effects do not work.
However, you can still set the built-in effects.
Effects Preset List
Preset name Effects
HALL 1 (default
value)
This is a bright reverb modeled after a large
hall-like space.
HALL 2
This is a warm reverb modeled after a large
hall-like space.
ROOM
This reverb is modeled on a small indoor
space.
STUDIO This reverb is modeled on a studio-like space.
PLATE 1 This is a bright plate reverb.
PLATE 2 This is a warm plate reverb.
8 – Using the Effects