Sundance SMT950 - Manual (Page 22)

Version 2.0 Page 22 of 52 SMT950 User Manual
The male power connector is located on the mezzanine card. The Samtec Part
Number for this connector is BKT-133-03-F-V-A
The mated height between the main module and the daughter card is 5 mm.
Some JTAG Lines are also mapped onto this connector to be used in case the
Daughter module would have a TI Processor. They would allow debugging and
programming via JTAG.
The following table shows the pin assignment on the power connector:
2 1
33
Pin Number Pin Name Description of Signal
1 D+3V3 Digital 3.3 Volts
2 DGND Digital Ground
3 D+3V3 Digital 3.3 Volts
4 DGND Digital Ground
5 D+3V3 Digital 3.3 Volts
6 DGND Digital Ground
7 D+3V3 Digital 3.3 Volts
8 DGND Digital Ground
9 D+5V0 Digital 5.0 Volts
10 DGND Digital Ground
11 D+5V0 Digital 5.0 Volts
12 DGND Digital Ground
13 D+5V0 Digital 5.0 Volts
14 DGND Digital Ground
15 D+5V0 Digital 5.0 Volts