Sierra Video View Multi-Viewer MV-XX - Manual (Page 35)

SIERRA VIEW
29
Configuration mode
The Sierra View has an on-screen configuration menu as an alternative means of
accessing IP configuration settings. This can only be accessed by using the SV-Remote
panel. A suitable display device must be connected to one of the DVI-I output ports.
To enter configuration mode from normal mode (with the red Lock LED off) hold the Lock
button down for about 3 seconds. The configuration or ‘menu’ mode will be entered, an
on-screen menu will appear and the red Lock LED will illuminate. If the Lock button is
depressed again, any changed settings will be saved and the unit will return to normal.
The currently loaded CPU firmware version will be indicated at the top of the on-screen
menu.
The main ‘menu’ mode controls are as follows:
Function keys (↑↓) scroll the menu cursor up and down to select the desired function.
Select Parameter keys (← →) select settings to apply to the chosen parameter.
Lock button exits ‘menu’ mode and saves settings.
Select submenu when the menu name is highlighted, or change
Parameter value within menu
Select item in menus and sub-menus
Press Lock to save changes and exit menu mode
System configuration Parameter(s)
Network Settings Set Manually (using settings below) / Use DHCP
IP Address Enter frame IP address byte at a time in the sub-menu
Netmask Enter Subnet Mask byte at a time in the sub-menu
Gateway If required, enter the Gateway address byte at a time in
the sub menu
DNS Server 1 If required, enter the DNS server address byte at a time
in the sub-menu
DNS Server 2 If required, enter the DNS server address byte at a time
in the sub-menu