Sierra Video View Multi-Viewer MV-XX - Manual (Page 19)

SIERRA VIDEO
13
Installation
Introduction
The Sierra View 3U frame may be installed in 19 inch bays and has a depth of
approximately 462mm, including connectors. Ventilation is assisted by cooling fans
located on the removable front panel of the frame. Exhaust grilles are located on the
upper panel, at a depth of approximately 370mm from the front panel. If installing other
equipment immediately above, it is essential that the ventilation outlet is not obstructed.
Frames should be installed into bays such that airflow is not impeded in any way.
Note:
The front rack ears are intended to provide a means of retaining the unit in the rack. To
insure adequate support the unit MUST also be supported at the rear of the frame.
Chapter 2