REMKO MHP-Manager Wireless Remote Control - Manual (Page 9)

Display menu
The parameters are selected using the rotary knob.
(HA = heating appliance)
System
Parameter Function Comments
Outdoor temp. Displays the outdoor temperature
The measured outdoor temperature is smoothed for
the controller. The smoothed value is displayed here.
Actual/Target HA
temp.
Temperature of the heating appliance
After pressing the F-key, the target value appears.
The target value corresponds to the highest temperature
requested of the heating system by the consumer circuits
(incl. water heating). The mixer circuits request your
required temperature + heating curve distance (specialist
value)
Modulation
Modulation depth of the heating appliance
(bus) Only if a modulating heating appliance is connected via
a bus and is transmitting values.
Burner 1 Burner relay 1 status (On/Off)
Burner 2 Burner relay 2 status (On/Off)
Error Error number; 00 = no errors
This menu only activates the display itself. No adjustments can be made here. The values are only shown if the
sensor is connected or the values are available, otherwise “----” or nothing are displayed.
You can leave the menu by pressing “Cancel”.
Hot water
Parameter Function Comments
Actual/Target HW
temp.
Current hot water temperature and current
target hot water temperature depending on
heating programme and operating mode
Display of the measured upper tank temperature
Lower HW temp. Lower HW tank temperature (infeed/solar)
Lower tank temperature
Only if a sensor is connected for the lower tank and
the charging function is activated
HW demand
Demand for water heating
On => Temperature not reached
Hot water status indicator
HW pump
Operation of hot water charging pump
On => e.g. after charge pump lock
Hot water status indicator
Enable HW
Enable water heating
On => Enable according to time programme
Hot water status indicator
9