REMKO MHP-Manager Wireless Remote Control - Manual (Page 18)

Service menu
Values (parameters) are summarised here in order to enable quick access for customer service.
Parameter Comments
Software number XXX.XX
Software number with index (please provide if you
have any problems/questions about the controller)
Reset user Reset all user parameters to factory settings
Reset specialist
(only with code no.)
Reset all specialist parameters to factory settings
Reset time programme Reset all time programmes to factory settings
Communication KM Heating appliance on the bus
Communication MM Mixer module on the bus
Specialist menu
These settings for use by specialists
can only be modified after entering
the code no.
Setting these values wrongly
could lead to malfunctions and
damage to the system.
CAUTION ! CAUTION
The code number is entered as
follows:
Set the first figure with
the rotary knob.
Select the next figure
using the F-key [==>]
Set the second figure
with the rotary knob.
Select the next figure
using the F-key [==>] Set the third figure with
the rotary knob.
Select the next figure
using the F-key [==>]
Set the fourth figure with
the rotary knob.
Save the code number
with the F-key [OK]
REMKO WIRELESS REMOTE CONTROL
FOR MULTITALENT HEAT PUMP MANAGER
18