REMKO MHP-Manager Wireless Remote Control - Manual (Page 8)

Overview of the operating menus
Menus Description Sub-menus Description
Display
Displays system values
(e.g. sensor and target values).
Adjustment is not possible.
This means that operating errors
in this menu are not possible.
System
All display values and settings relating to the heating
appliance or the system as a whole, or which cannot
be assigned to another consumer circuit.
Hot water
All internal display values and settings of the controller,
relating to water heating.
Heating circuit 1/2
All display values and settings relating to the associated
consumer circuit (even as a decentralised hot water
circuit, for example).
Solar / MF
All display values and settings relating to solar energy
generation and setting the multifunction relay.
User
Summary of settings that can be
adjusted by the operator.
System
All display values and settings relating to the heating
appliance or the system as a whole, or which cannot
be assigned to another consumer circuit.
Hot water
All internal display values and settings of the controller,
relating to water heating.
Heating circuit 2
All display values and settings relating to the associated
consumer circuit (even as a decentralised hot water
circuit, for example).
Time
pro-
gramme
Summary of the time
programmes for the heating
circuits, the hot water circuit
and additional functions, as
applicable
Heating circuit x
Prog 1
All display values and settings relating to the associated
consumer circuit (even as a decentralised hot water
circuit, for example).
Heating circuit x
Prog 2
All display values and settings relating to the associated
consumer circuit (even as a decentralised hot water
circuit, for example).
Hot water
All internal display values and settings of the controller,
relating to water heating.
Time
Date
Time, date, holiday programme
and data on daylight savings
time
Time Set hour
Date Set date
Start holiday Set date for start of holiday period
End holiday Set date for end of holiday period
Start daylight savings Set date for start of daylight savings time
End daylight savings Set date for end of daylight savings time
Service
Summary of the values for
service technicians
Software number Software number with index
Reset user Reset all user parameters to factory settings
Reset specialist Reset all specialist parameters to factory settings
Reset time
programme
Reset all time programmes to factory settings
Communication KM Heating appliance on the bus
Communication MM Mixer module on the bus
Specialist
Summary of the values which
require a specialist to adjust
them (installer).
Values in the Specialist menu
are protected by a code no.
(damage/operating errors
possible)!
System
All display values and settings relating to the heating
appliance or the system as a whole, or which cannot
be assigned to another consumer circuit.
Heating circuit
All display values and settings relating to the associated
consumer circuit (even as a decentralised hot water
circuit, for example).
On the following pages you will find detailed descriptions of the different menus and their parameters.
REMKO WIRELESS REMOTE CONTROL
FOR MULTITALENT HEAT PUMP MANAGER
8