REMKO MHP-Manager Wireless Remote Control - Manual (Page 15)

Heating period 1 Heating period 2 Heating period 3
Mon
Tues
Wed
Thurs
Fri
Sat
Sun
Time programmes menu
Adjusting a time programme
All time programmes can be set in this menu.
Parameter Comments
Programmes with the controller at its maximum configuration
Heating circuit x Prog 1 1st heating programme
Heating circuit x Prog 2 2nd heating programme
Hot water Programme for hot water charging
Adjusting a time programme works as follows:
Heating circuit
Heating programme 1 => Factory setting:
Mon to Fri: 6:00am to 10:00pm
Sat and Sun: 7:00am to 11:00pm
Press the “Time pro-
gramme” F-key
Choose the desired time
programme using the rotary
knob => e.g. “Heating
circuit x Prog 2”
Use the F-key (in this case
the second key down) to
select the time programme
=> “Heating circuit x Prog 2”
“Monday”
Use the rotary knob to
choose the day of the
week or block
=> e.g. “Mon - Fri”
(Monday - Friday)
Select the block with F-
key [OK]
=> „06:00 -- 08:00“,
„16:00 -- 22:00“,
--:-- -- --:--„
Select Time with the F-
key [==>]
=> „06:00 -- 08:00“,
„16:00 -- 22:00“, --:-- --
--:--„
Adjust the time with the
rotary knob
=> „06:00 -- 08:00“,
„17:00 -- 22:00“, --:-- --
--:--„ Select the next time using
the F-key [==>]
Use the F-key [OK] to
save the new programme
Use the F-key [Cancel] to
leave the block without
saving
15