REMKO MHP-Manager Wireless Remote Control - Manual (Page 27)

1. Read this manual carefully
before commissioning.
2. Fit the controller (see chapter
“Installation”).
3. Wait until the message
Installation appears on the
display.
4. Start installation with the F-key
[4] = OK.
5. Set the value with the rotary
knob.
6. Press F-key [4] = OK => Saves
the value and moves to the
next value.
7. Continue until installation is
complete => Standard display
8. Set the Programme switch to
the desired operating mode,
e.g. Automatic 1 (see chapter
“Operation/Mode selection”)
Assembly
1. Secure the base to the wall.
2. Setting the channel:
On the back of the wireless
remote control the channel
(0 – 2) must be set, while the
batteries are removed.
The setting must match that on
the HF-CAN.
3. Insert the batteries.
4. Snap the top of the controller
into place; to do so, position/
hook in the left-hand side so it
is centred and then pivot the
right-hand side down onto the
base using light pressure and
engage.
Installation
Channel setting 0
Channel setting 1
Channel setting 2
ON
OFF 1 2 3 4
Dip 1-4
ON
OFF 1 2 3 4
Dip 1-4
ON
OFF 1 2 3 4
Dip 1-4
The dimensions of the unit are: 147mm x 97mm x 32mm
The mounting holes are suited for fitting to a switch box
A cable feedthrough is provided.
Disassembly
1. Lift the upper section off
the base on the right-hand side.
2. Unscrew the base from the wall.
Commissioning
The following steps must be
followed when commissioning: BUS CODE (heating circuit number):
The heating circuits are numbered sequentially, starting with “01”. Heat-
ing circuit numbers must not be assigned more than once. Please only
use “00” for replacement controllers (see chapter “System bus”).
For information on registration, see chapter “Specialist menu”.
In the Commissioning menu, all values must be entered successively –
without interruption!
Values Required action
English Set language, then “OK”
Set time
1. Hour then “==>”
2. Minute then “OK”
Set date
1. Year then “<==”
2. Month then “<==”
3. Day then “OK”
Bus code
(see chapter System bus) Enter number for heating circuit:
00-15 => Default 01, then “OK”
Registration Registration on the HF-CAN
27