REMKO MHP-Manager Wireless Remote Control - Manual (Page 17)

Parameter Function Comments
Time (hh:mm) Set hour, F-key [==>], hh:mm, set minutes
(Not with a time master or DCF in the system)
The clock may lose up to 2 minutes each month
(if necessary, please correct the time). If a DCF receiver is
connected, the correct time is always displayed.
Time master for all controllers
If one controller in the heating system has been set as
a time master (to provide the time for all controllers,
see Specialist/System) or if a DCF (radio time receiver)
is installed in the system, the option to enter the time is
hidden on all the other controllers.
A maximum of one time master can be set on the bus.
Date (dd. Month yy)
Set year, F-key [<==], set month, F-key
[<==], set day
Please set the year and month first. Then the correct
number of days in the month is calculated for the selected
values.
Start holiday
(dd. Month yy)
Set date for start of holiday period
Holiday function
Please do not enter the date of your departure as the
start date, but rather the first full day of the holiday
(the heating will be switched off on this day).
Please do not enter the date of your return as the end
date, but rather the last day on which the heating should
be switched off. When you arrive home, your residence
and the water for your shower should already be warm.
Cancel the holiday function => e.g. if you arrive home
prematurely, by pressing the Programme key.
End holiday
(dd. Month yy)
Set date for end of holiday period
Start daylight savings
(dd. Month)
Set date for start of daylight savings time
Automatic daylight savings switchover
The current day of the week is calculated automatically.
You can check this using the freely selectable additional
indicator on the standard display => setting to “Day of the
week”.
The automatic daylight savings switchover is made possible
by entering the date.
The default setting is for central European time zones.
It need only be changed if legislation is passed to change
the date on which daylight savings takes effect.
The earliest date on which the switchover will take place
must be set. The controller will carry out the switch
change on the Sunday following the set date at 2:00 or
3:00 in the morning.
If you do not want the switchover to take place, please
set the Stop month to the Start month and the Stop day to
the Start day.
End daylight savings
(dd. Month)
Set date for end of daylight savings time
Time/Date menu
Various values (parameters) are summarised here for the user, in order to provide quick access.
17