REMKO GPM 15 - Manual (Page 19)

19
ATTENTION
In a heating mode, parameter
10 must be reset to the value 0.
Summer mode (only
ventilation)
In the summer months, ventilation
can also take place via the
temperature control ATR-6.
However, this function must
initially be activated on the control
board.
Setting parameter value
Press and hold the KM button
for about 10 seconds until the
following display appears.
K4 K3 K2 K1
KM
K-
K+
Info Reg err
Press the K4 (>>) button to access
the following display.
Press the K4 (>>) button to access
the following display.
K4 K3 K2 K1
KM
K-
K+
spra par park
Press the K3 park button and in
the following display press the
K4 (>>) button several times until
param k 10 appears.
With the K+ or K- button, set the
value to 1.
Press and hold the KM button for
10 seconds to return to the basic
display again.
K4 K3 K2 K1
KM
K-
K+
param k 10
1
Setting the PROG SAN value
To set the ventilation function, the
prog san value must be set to the
appropriate mode.
The procedure is as follows:
Press the KM button, the following
display appears.
K4 K3 K2 K1
KM
K-
K+
HZG san info
K4 K3 K2 K1
KM
K-
K+
HZG san info
Activating/deactivating
ventilation
Press the KM button, the following
display appears.
K4 K3 K2 K1
KM
K-
K+
prog reg uhr
Press the K4 (>>) button several
times until prog san appears.
With the K+ or K- button, set the
value to 1.
Press the K2 reg button to access
the following display.
K4 K3 K2 K1
KM
K-
K+
tem raum t1
10,0
K4 K3 K2 K1
KM
K-
K+
prog san
1
This operation can be ended by
pressing the KM button.
K4 K3 K2 K1
KM
K-
K+
on off uhr
The ventilation function can be
activated with the K2
on button
or deactivated with the K3 off
button.
Ventilation mode on is indicated
on the display with a water tap
symbol.
Ventilation can be programmed
for a fixed time with the K4
uhr
button.
The timer can be set up to 12
hours in 30 minute steps.
A water tap symbol and
timer are
indicated on the display.
NOTE
The timer program can be
ended prematurely by pressing
the
KM button, the K2 san
button and the K3 off button.
By pressing the K2 san button, the
following display appears.