REMKO GPM 15 - Manual (Page 12)

12
REMKO GPM
Due to their design and
equipment, the units are
intended solely for heating and
ventilation purposes in industrial or
commercial use (not for domestic
heating).
The design of the unit allows the
use of accessories approved by the
manufacturer.
The appliances must only be
operated by suitably trained
personnel.
The manufacturer disclaims all
liability for any damage attributed
to failure to observe relevant
instructions, statutory requirements
applicable at the place of use or
unauthorised changes to the unit.
Improper use of the units is not
permitted.
The units must be installed
by a qualified installer who is
responsible for adhering to the
existing rules, regulations and
directives.
Customer service and
warranty
A precondition for any warranty
claims is that the dealer or his
customer has completed and
returned the enclosed “warranty
document
” to REMKO GmbH &
Co. KG.
The units were repeatedly tested
for perfect functioning at the
factory.
If problems should occur
which cannot be remedied by
troubleshooting by the operator,
your specialised dealer or contract
partner should be contacted.
Intended use
Disposal of packing
When disposing of the packaging
material, please think of the
environment.
Our units are carefully packed for
transport and delivered in sturdy
cardboard packaging on a wooden
pallet, if necessary.
The packaging materials are
environmentally-friendly and can
be recycled.
By reusing packaging materials,
you make a valuable contribution
towards waste reduction and the
conservation of raw materials.
Only dispose of packaging
material at the facilities provided.
Disposal of old unit
Our production is subject to
constant quality controls.
Only high-quality materials are
used, the majority of which are
recyclable.
Make your contribution towards
environmental protection by
disposing of your old unit in an
environmentally-friendly manner.
Only dispose of your old unit at
an authorised recycling facility or
similar.
Environmental
protection and
recycling
Improper use of the units is
not permitted.
The units must be installed
by a qualified installer who is
responsible for adhering to the
existing rules, regulations and
directives.
NOTE
Adjustments and maintenance
must only be carried out by
authorised specialists.
NOTE
ATTENTION
Copyright
No part of this
documentation may be
reproduced or used for any
other purposes than the
intended without the express
prior written permission of
REMKO GmbH & Co. KG.