REMKO GPM 15 - Manual (Page 13)

13
param k TSP GPM 15 GPM 25 GPM 35 GPM 55 GPM 75
1 A1 44 55 62 65 75
2 A2 58 73 93 93 98
3 A3 83 83 80 70 70
4 A4 5
5 A5 10
6 A11 25
7 A17 4
8 A28 50
9 A34 10
10 A35 0
11 C1 0
12 C3 60
13 C4 120
14 C5 0
15 C8 0
16 ST3 5
17 A12 0
18 A16 2
19 A24 2
20 A15 0
21 A31 2
22 A43 0
23 A44 0
GPM control board parameter table
The values in the aforementioned table are factory default settings
K4 K3 K2 K1
KM
K-
K+
Info Reg err
Press the K4 (>>) button, the
following text display appears.
K4 K3 K2 K1
KM
K-
K+
spra par park
Press the K3 park button; the
text line param k 1 . appears in the
following display.
The parameters param k 1 to 3 can
be selected with the K4 (>>)
up button
, or K1 down button
(<<).
The respective values displayed
at the top can be changed as
appropriate with the K+ or K-
button.
Press and hold the KM button for
10 seconds to return to the basic
display.
K4 K3 K2 K1
KM
K-
K+
param k 1
62
Adjusting parameter values
Press and hold the KM button
for about 10 seconds until the
following display appears.
ATTENTION
All unit parameters can only
be changed in conjunction
with the electronic
temperature control ATR-6.
ATTENTION
Changes to parameters may
only be made as described in
these operating instructions
and approved.
Where customer-specific
parameter changes are made,
these must be documented in the
aforementioned table.
In the event of control board
replacement, the values must be
reprogrammed.
See also (page 33) „Control board
replacement“.
Parameters can only be
adjusted when the unit is not
in operation.
NOTE