REMKO GPM 15 - Manual (Page 18)

18
REMKO GPM
K4 K3 K2 K1
KM
K-
K+
HZG san info
Press the K1 hzg button, the
following display appears.
Timer mode
In this mode, the temperature con-
trol operates within a fixed time
window.
Press the KM button,
HZG appears
on the left in the text bar.
Press the K1
HZG button and in the
following display press the K4 uhr
button.
In the following display, set the
flashing time/hour indication to
the required value with the K+ or
K-
button.
K4 K3 K2 K1
KM
K-
K+
timer
4 6 8 10 12 14 16 18 20 22 24 2
17:00 fr
24,0
The timer mode is indicated in the
display with
timer .
The timer can be set up to 12
hours in 30 minute steps.
After lapse of the timer program-
med time, the unit switches back
to the automatic mode again.
K4 K3 K2 K1
KM
K-
K+
dauer temp
20,0 02:00
Press the K4 temp button and set
the flashing temperature indication
to the required value with the K+
or K- button.
Press the KM button to return to
the operational display.
Fault message display
The temperature control ATR-6
can display possible system faults
and supply diagnostic information.
Possible Unit faults are indicated
by a flashing triangle and ”Reset
heating”
in the following display.
!
K4 K3 K2 K1
KM
K-
K+
reset
4 6 8 10 12 14 16 18 20 22 24 2
08:25 di 18,5
kessel
!
K4 K3 K2 K1
KM
K-
K+
fehlercode
!
1
Faulty code analysis is described in
the chapter “Troubleshooting” in
the operating instructions.
By pressing the K4 (>>) button,
the fault code (e.g. 1) is displayed.
NOTE
After 5 unsuccessful reset att-
empts, the control electronics
of the unit are permanently
locked.
In order to restart the unit, it
must be disconnected from the
mains supply.
NOTE
The timer program can be
ended prematurely by pressing
the
KM button, the K1 hzg but-
ton and the K1 auto button.
NOTE
The heating program can be
reactivated by pressing the
KM
button, the K1 hzg button and
the K1 auto button.
Prior to troubleshooting and
clearing faults, no reset must be
performed.
ATTENTION
K4 K3 K2 K1
KM
K-
K+
auto on off uhr
Switch off the unit
Press the KM button, HZG appears
in the text bar.
K4 K3 K2 K1
KM
K-
K+
13:50 fr 20,0
NOTE
In this mode, frost protection
is automatically activated at a
temperature of 5°C.
Press the K3 off button, the fol-
lowing display and symbol appear.
After locating and clearing the
fault, the unit must be reset via the
K1
reset button.