REMKO GPM 15 - Manual (Page 15)

15
Do not use any pointed
objects such as ball-point
pens or pencils for pressing
the buttons as these can be
damaged.
ATTENTION
4 6 8 10 12 14 16 18 20 22 24 2
°C AM
PM !
K+ button
K– button
KM button
K3 button K1 button
Room
temperature
Text bar
K4 button K2 button
Day,
Hour,
Minutes
Error display
Ventilation mode Manual mode
Heat demand
Heating mode Switch off mode Timer
programming
LCD display
The temperature control ATR-6 uses an alphanumeric LCD display, as
shown below.
There is a choice of three
languages: German, English and
French.
Press the K1 button and select the
required language with the K+ and
K-
buttons.
Confirm the language selection
with the K4
OK button.
Press and hold the KM button for
10 seconds to return to the basic
display.
K4 K3 K2 K1
KM
K-
K+
tag std min
16:00 mo
Set clock
Press the KM button, HZG appears
on the left in the bottom text bar.
Press the K4 (>>) button, the
following display appears.
Set the language
Starting display with initial use.
K+
K-
KM
K1 K2 K3 K4
4 6 8 10 12 14 16 18 20 22 24 2
09:38 mo 20,0
Press the KM button once briefly
(only for initial use).
Press and hold the KM button for
about 10 seconds until the text
display in the bottom text bar
changes from Chau to Info.
K4 K3 K2 K1
KM
K-
K+
chau heur min
16:o2 lu
K4 K3 K2 K1
KM
K-
K+
Info Reg err
Press the K4 (>>) button to change
from display Info to „Lang“ (Lan-
guage).
K4 K3 K2 K1
KM
K-
K+
lang par parc
With K3 select Uhr and the
following display appears.
K4 K3 K2 K1
KM
K-
K+
prog reg uhr
With the K1, K2 and K3 buttons,
select the week day, hour and
minutes.
The current selection is indicated
by flashing.
The K+ and K- buttons increase
and decrease the displayed
parameter value.
Press the KM button to exit the
level.