Q-See QC40198 - Manual (Page 107)

WEB OPERATION
QC40198 User Manual
98 | P a g e
Please refer to the following chart for detailed information.
Parameter Function
NAS enable
Select network storage protocol and then enable NAS
function.
Server IP Input remote storage server IP address.
Port
Input remote storage server port number.
User Name
Log in user account.
File length The file length you upload to the FTP.
When setup is larger than the actual file length, system
will upload the whole file. When setup here is smaller
than the actual file length, system only uploads the set
length and auto ignore the left section. When interval
value is 0, system uploads all corresponding files.
Password The password you need to log in the server.
Remote Path Remote storage file path.
Save You can click save button after you complete setup for
one channel, or you can complete the whole setups and
then click save button.
Refresh Click this button to get device’s latest configuration
information.
NTP
The NTP interface is shown in Figure 7-42.
Here you can activate network time synchronization. Please enable current function and then input server IP, port
number, time zone and update interval. Please note the SNTP supports TCP transmission only and its port shall be
123.The update interval ranges from 1 to 65535. Default value is 10 minutes.
Figure 7-42