Q-See QC40198 - Manual (Page 104)

WEB OPERATION
QC40198 User Manual
95 | P a g e
Function
PPPOE  Input the PPPoE user name and password you get from the
IPS (internet service provider) and enable PPPoE function.
Please save current setup and then reboot the device to
get the setup activated.
 Device connects to the internet via PPPoE after reboot.
You can get the IP address in the WAN from the IP address
column.
 Please note if you want to reboot the device please make
sure you have proper reboot right and there is no user
logged in.
Email
The email interface is shown in Figure 7-39.
Figure 7-39
Please refer to the following chart for detailed information.
Parameter Function
SMTP Server
Input server address and then enable this function.
Port Please input port value here.
User Name
The sender email account user name.
Password
The sender email account password.