D-Link DI-1162 - Manual (Page 71)

DI-1162 Remote Access Router
Configuration and Management 61
•
^M – or .
♦
Delay – will delay for the number of seconds defined in the
Parameter field.
♦
Get My IP – Will get the IP address from the ISP if the ISP
sends it. This command is only valid for SLIP connections.
♦
Get Srv IP – Will get the Servers IP address if it is sent. This
command is only valid for SLIP connections.
♦
End – Ends the script file.
Parameters
Parameters are data fields which hold text or numbers that are used in
the
Wait, Transmit and Delay commands.
State
Toggles to enable or disable the line item.
DHCP Configuration
The DI-1162 Router implements the Dynamic Host Configuration
Protocol (DHCP), which allows the entire IP network to be centrally
managed by the router. It does this by assigning IP addresses and
configuration parameters to hosts as they are powered on and come
onto the network. This can be a great help for network administration
since many administrative tasks such as keeping track of each
computer’s IP address are handled by the router. The DI-1162 can
implement DHCP in one of the two ways shown below: