D-Link DI-1162 - Manual (Page 135)

DI-1162 Remote Access Router
PROM System Configuration 125
Items listed in the above menu are described as follows:
•
Software Update Control – this toggles disable, enable.
•
Software Update Mode – this specifies downloading the image
file from a Network server on the local LAN.
•
Boot Protocol – this setting is for a local network download and
has two options TFTP and BootP&TFTP.
•
TFTP – a File Transfer Protocol. Using this setting assumes
all other items on this screen have been filled out.
•
BootP&TFTP – BootP is run first and sends your router IP
Addresses for the TFTP server and the router, and tells the
router the path to the software update (image file). Then TFTP
will be used to download the image file.
•
Boot Server IP Address – this specifies the IP address of the
server to be used to download the image file.
•
Boot File Name – this specifies a complete path and filename on
the TFTP server. If you choose to use a configuration file, this
setting must show the path and filename to the configuration file. If
you are not using a configuration file, this must show the path and
filename to the software update image file.