D-Link DI-1162 - Manual (Page 20)

DI-1162 Remote Access Router
10 Installation
LED STATUS/ FUNCTION
Power Lights whenever the router is plugged in, turned on, and thus
receiving power.
Diag Lights during the startup POST test.
Boot Lights briefly during startup after the PROM program has
executed. Indicates a successful boot up.
Run Should be slowly blinking if the router is functioning properly.
10/100 This LED is ON for a 100Mbps link, and OFF for a 10Mbps
link.
LAN
Link/Act This LED is ON to show a good link to the LAN, and quickly
flashes to show communication activity on the line.
Full/Half This LED is ON for a full-duplex connection, and OFF for
half-duplex.
Col The LED flashes to show transmission collisions on the line.
WANs
1 & 2
Ready This LED is ON to show a good modem or CSU/DSU link to
the WAN port.
Act This LED flashes to show communication activity on the line.
Module
Ready This LED is ON to show a good modem or CSU/DSU link to
the WAN module, or a good link to the LAN port module.
Act This LED flashes to show communication activity on the line.