ONICON F-2600 - Manual (Page 54)

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699 • [email protected]
F-2600 & F-2700 Vortex Flow Meter Manual 02/15 - 0808-7 / 19204 Page 54
3.2 START-UP
To begin flow meter operation:
1. Verify the flow meter is installed and wired as described in Section 2.
2. Apply power to the meter. At start-up, the unit runs a series of self-tests that check the RAM,
ROM, EPROM and all flow sensing components. After completing the self-test sequence, the
Run Mode screens appear.
3. The Run Mode displays flow information as determined by system settings. Some screens
depicted on the next page may not be displayed based on these settings. Press the ⇑ ⇓ arrow
keys to view the Run Mode screens.
4. Press the ENTER key from any Run Mode screen to access the Set-up Menus. Use the Set-up
Menus to configure the meter’s multi-parameter features to fit your application.
i IMPORTANT NOTICE
Starting the flow meter or pressing EXIT will always display the Run Mode screens.