beautypg.com

ONICON D-1200 Series User Manual

ONICON Measuring instruments

background image

11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax (727) 442-5699

www.onicon.com • [email protected]

D-1200 SERIES DISPLAY MODULE

INSTALLATION INSTRUCTIONS AND WIRING DIAGRAM

0610-1

05-14

SITE SELECTION

Find an easily accessible location where wire connections can be made and meter readings can be

taken from floor level. Mount the Display Module enclosure on a vibration free surface. Avoid

locations such as the plenum of a fan coil, heat exchanger, VFD or any housing that may contain

electric motors or other strong sources of electrical interference.

MECHANICAL INSTALLATION

ELECTRICAL INSTALLATION -

(Contact ONICON for a wiring diagram specific to the serial number of your display.

)

OPERATING THE DISPLAY MODULE

When power is applied to the display module, the power on LED will light and the black

LCD display segments will illuminate. The display(s) will indicate flow data if the flow

meter(s) is connected and there is flow in the pipe.

The letter “R” will precede the displayed value when the display is indicating a flow rate

such as GPM. Values shown without “R” preceding the number are totals.

For displays configured to indicate both rate and total, use the SEL button to toggle the

display between rate and total values.

• Engineering units and multipliers are shown immediately below the display as shown

above. Multiply the current reading by the mulitplier to determine the correct rate

and/or total.

• The RST button, if enabled, will reset accumulated totals to zero when pressed. ONICON

display modules are shipped with the RST button disabled. Contact ONICON if you wish

to enable this function. The display will indicate “Cnt OVEr” when the total exceeds the

maximum count.