Figure 71: almanac loader screen – NavCom SF-3050 Rev.I User Manual
Page 80
SF-3050 GNSS Product User Guide
– Rev I
61
Drive A consists of the internal memory card of the SF-3050. It is formatted and
segmented by using the [FSFORMAT] command (see
Chapter 1).
Drive B consists of a USB memory device that can be configured as follows:
1. Connect the 9-pin Male end of the USB Host cable (94-310271-3006LF) to the
COM-2 port on the SF-3050. Plug a USB flash drive into the USB Female end of
the cable.
2. Type [USBMODE]DEVICE, MASS STORAGE in the Input Terminal screen. This
command will format the USB device as Drive B.
The USBMODE command automatically defaults to COMPORT. In order to
log data onto a USB device, this command needs to be changed to MASS
STORAGE.
Almanac Loader
Figure 71: Almanac Loader Screen
Click Choose File button to select a file from the desired directory. Click Inject to install
the almanac in the receiver memory.
Click the GPS link to download the current GPS almanac into the browser. The
GLONASS almanac can be downloaded the same way.
The Save/Open Current Almanac feature is only available in Firefox and
Chrome browsers.
Options and License
This screen lists the Software Options loaded into the receiver and the status of the
primary and secondary license.
It is also possible for the user to upload current license software as well as other software
options by using the File Upload feature.