NavCom SF-3050 Rev.I - Manual (Page 132)

SF-3050 GNSS Product User Guide – Rev I
A-113
A ........................................................ GNSS Module Specifications
The technical specifications of this unit are detailed below. NavCom Technology, Inc. is
constantly improving, and updating our technology. For the latest technical specifications
for all products go to:
http://www.navcomtech.com/Support/
This GNSS sensor is fitted with an internal Lithium cell battery used to maintain GNSS
time when power is removed from the unit. This allows faster satellite acquisition upon
unit power up. The cell has been designed to meet over 5 years of service life before
requiring replacement at a NavCom approved maintenance facility.
Features
 Full constellation coverage with up to 66 signals tracked simultaneously, plus the
StarFire channel
 SBAS (WAAS, EGNOS, MSAS, GAGAN) tracking
 Built in StarFire receiver and demodulator
 L1, L2, L2C, L5, G1, G2, E1, E5A (GPS/ GLONASS) code and full wavelength carrier
phase tracking
 High sensitivity/low signal level tracking
 Fast acquisition/re-acquisition
 Superior interference suppression (both in-band & out-of-band)
 Patented multipath rejection
 Minimal data latency
 2 GB of internal memory (Not supported in version 1.0 software)
 NavCom Ultra Compact RTK format, RTCM 2.3 and 3.0 (code & carrier), and
CMR/CMR+.
 Output NMEA 0183, NavCom Binary, NavCom ASCII formats
 Configurable as RTK base or rover
 MBRTK
 RTK Extend
 Heading
 Programmable output rates
 Event Marker input
 1PPS Output
 Communications Ports: RS-232, RS-422, USB 2.0 (Device & Host), Bluetooth, and
Ethernet
 StarFire over IP corrections via the Internet