NavCom SF-3050 Rev.I - Manual (Page 16)

SF-3050 GNSS Product User Guide – Rev I
xiv
added Table 27 and
Table 28 and a note regarding the reassignment of satellites ID #
609 and # 643
Appendix E: added this appendix (Networked Transport of RTCM
Internet Protocol Setup)
Appendix F: (formerly Appendix E)
Glossary: Updated table references
Rev C
(Nov. 2009)
Removed all references to Tall L-band antenna and combiner kit
Rev B
(Nov. 2009)
Added the Software License Agreement section to Notices, and
added Appendix E Software License Agreement
Added information about MED Compass Safe Distance
Added information on equipment that is required to pass the
conducted MED type emission criteria
Extensively updated Firmware, Software Options, and StarFire
License sections in Chapter 1
Updated various screen captures of StarUtil 3000 in Chapter 1
Changed extensions to *.opt for Software Options File and *.lic for
StarFire License File
Added the part number for the Positronic plug on both data cables,
with the pin type
Changed reference
to “supplied GNSS antenna” to “supplied Rover,
Base, or Airborne antenna”
Added the caveat that the SF-3050 is IP67compliant only when
cables are connected
Updated information on the supplied unterminated DC power cable:
for Early Production Units the cable is without a filter (P/N 94-
310262-3010LF); for Later Production Units the cable has a filter
(P/N 94-310274-3010LF)
Revised section on the proper shutdown of the SF-3050 via ignition
pin
Removed 0x5D as a supported NCT RTK correction type
Rev A
(July 2009)
Initial release