NavCom SF-3050 Rev.I - Manual (Page 138)

SF-3050 GNSS Product User Guide – Rev I
A-119
Connector Assignments

By default, the two female Positronic ports are available for command
inputs and data input/output. Refer to Chapter 4, Interfacing, for I/O
connector pin assignments.
Input/Output Data Messages

See Related Standards at the front of this manual for information on the
various data formats.

In the most current version of the software, the DTM message will
automatically display before the most frequently scheduled NAV message.

In older versions of the software (v3.0.13 and earlier), the DTM message
must be manually scheduled to display at the same rate as the most
frequent NAV message to meet IMO and MED certification requirements.
v.3.0.14 and later software support NMEA-0183 v.1.4.1. See Sapphire
Technical Reference Manual for details.
ANT: TNC (female) RF Input, RF Ground
COM 1
– LAN:
(connector:
FR11MP922LM0/AA
pin: MC422N/AA)
Positronic (female)
RS-232, from 9.6 to 115.2 kbps
Ethernet, from 10 to 100 Mbps
1PPS
COM 2 – USB:
(connect same as COM1)
Positronic (female) RS-232/RS-422, from 9.6 to
115.2 kbps, USB 2.0, 12 Mbps max data rate
POWER: (connector:
FR11FP922LM0/AA; pin:
FC422N6/AA). Positronic (male)
Power port, from 9 to 32 VDC, 6 W typical, Power
Input 1,2; Power Ground 1PPS / Event Marker
BLUETOOTH: 1 Serial Port Service, 230.4 kbps
10 m (32 ft) range
Control Commands
(Input Only):
NavCom proprietary commands (refer to TRM)
Differential Correction
(I/O): RTCM 2.3 and 3.0, RTCM types 1, 3, and 9, SBAS
(WAAS/EGNOS/ MSAS/ GAGAN), and StarFire
RTK Correction
Data (I/O):
CMR/CMR+, RTCM types 3, 18-22, and 1001-1012,
1019-1020, 1033; NCT types 0x5B, 0x5C, and 0x5E
(hex)
NMEA-0183
Messages
(Output Only):
ALM, DTM, GFA, GNS, MLA, GBS, GGA, GLL, GRS,
GSA, GST, GSV, HDT, RMC, RRE, ROT, TTM, VTG,
ZDA