MovinCool Classic 40 Service Manual - Manual (Page 57)

Repair Section
57
7.4 Removal of Condenser Fan Assembly
1) Take out the two (2) screws, and then remove the
sub-control box cover.
2) Disconnect the three (3) power supply wires from
the terminal, and disconnect the ground wire.
3) Take off the nut (left-handed screw) and two (2)
washers, and then remove the condenser fan.
CAUTION
• Tightening torque (for Installation):
- 32.5 ± 3.6 ft•lbf (44.1 ± 4.9 N•m)
4) Take off the four (4) nuts, and then remove the
condenser fan motor.
I002637
Screws (2)
Sub-Control Box Cover
I002638
Power Supply Wires (3)
Terminal
Ground Wire
I002639
Fan
Nut (1)
(Left-Handed Screw)
Washers (2)
I002640
Nuts (4)
Motor Stay
Fan Motor