MovinCool Classic 40 Service Manual - Manual (Page 31)

Operation Section
31
5.7 Basic Operation
(1) Control panel
• Before operating the unit, it is important to be familiar with the basic operation of the control panel.
< NOTE >
• The room temperature display range is from 0 °F to 109 °F.
(When displayed in “°C ” the range is from -9 °C to 60 °C)
• In Fahrenheit only, when the display value is greater than 99 °F, 100 °F, 101 °F, and 109 °F are
displayed as “00”, “01”, and “09” respectively.
I003025
Activates/deactivates the cool mode; turns the unit off. COOL ON/OFF Button
Activates/deactivates the fan only mode; turns the unit off. FAN Button
Increases/decreases the temperature set point during cool mode.
Shows a blinking set point temperature for 5 sec, then continuously indicates room
temperature. Room Temperature/
Set Point Display
Illuminates to indicate the current temperature being displayed is either in °C or °F. Temperature Scale LED
Illuminates during fan only mode and cool mode using fan operate mode. ON LED
Illuminates during cool mode using fan stop mode.
Right decimal segment is on
Indicates wall thermostat enable
function is set.
Indicates set point temperature
when display is flashing.
(Left fig. : Set Point temp. at 75 °F)
Power stand by or during fan only mode
Lit during wall thermostat connection.
During set point temperature adjustment
or cool mode on.
(5 sec)
AUTO LED
SET TEMP Buttons ( / )
1
2
4
5
6
7
[LED Display Indication] In normal operation, LED displays the following indication.
3
Display Indication Conditions
Indicates room temperature
when display is solid.
(Left fig. : Room temp. at 78 °F)
During cool mode
5
6
4
1
2
7
3