MovinCool Classic 40 Service Manual - Manual (Page 24)

Operation Section
24
5.3 Power Supply Requirements
(1) Plug Connection
• Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are present,
wipe off with a clean, dry cloth.
• Check the power cord, plug and prongs for damage or excess play. If any damage or excess
play is found, contact your MovinCool reseller or a qualified technician for repair.
WARNING
• If the power cord or plug is damaged, repair should only be performed by qualified
electrical personnel.
• Do not connect/disconnect the power cord or attempt to operate buttons with wet hands.
This could result in electrical shock.
• The power supply should be a dedicated single outlet circuit with a UL approved short-
circuit and ground fault protective breaker with a recommended fuse size of 25 A (25 A
maximum).
• Because of potential safrety hazards under a certain condition, we strongly recommend
against the use of an extension cord. However, if you still elect to use an extension cord,
it is absolutely necessary that it is a UL listed, 4-wire grounding type appliance extension
cord, having a 4-blade grounding plug and a 4-slot receptacle that plugs into the
appliance. The marked rating of the extension cord should be 220 V, 25 A or equivalent.
CAUTION
The AC outlet should be rated minimum 25 A at 220 VAC, 3 phase, 60 Hz. Do not share the out-
let with any other instrument or equipment.
< NOTE >
• Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign matter.
• The Classic 40 is equipped with an approved NEMA plug configuration (L15-30). The appropriate
outlet must be used for this plug type.