MovinCool Classic 40 Service Manual - Manual (Page 28)

Operation Section
28
5) Install the wall thermostat to the proper location inside the room where it can be conveniently
accessed. Do not install the wall thermostat where unusual heating conditions may occur (i.e.
hot stove, hot pipe, fireplace, direct sunlight, etc.)
Most thermostats provide these basic functions:
- Fan Mode: On / Auto (Select the desired fan mode)
- System: Cool / Heater (Select Cool only)
- For wall thermostat operation, see the operation manual supplied with the wall thermostat.
(2) Setting unit for wall thermostat connection
1) Press and hold FAN button, SET TEMP UP
 and DOWN  buttons simultaneously to activate
wall thermostat connection.
2) Press SET TEMP UP
 button to select “Sb” indicates on LED display for wall thermostat
enable function. (“Ho” indicates on display for wall thermostat disable function.)
3) Press COOL button to set wall thermostat function. If COOL button is not pressed within 10 sec.,
the setting is automatically confirmed.