MovinCool Classic 10 Service Manual - Manual (Page 71)

Repair Section 71
11. REASSEMBLY
11.1 Reassembly of Unit
• Reassemble the unit in the reverse order of removal. Described below are the parts that require
special care in reassembling the unit. Perform all wiring or rewiring as referenced in the wiring
diagram.
1) Install three (3) cushions and three (3) collars to
the bolts and mount the supplied compressor to
the unit.
Insert three (3) washers and tighten three (3) nuts. 2)
3)
< NOTE >
5)
4)
Re-install overload relay, wires, and plastic cover
after brazing.
CAUTION
• Tightening torque:
8.3 ± 2.1 ft•lbf (11.3 ± 2.9 N•m)
Remove the plastic cover, wires and overload relay
from the compressor before brazing.
ILL00605-00
Compressor
Nut (3)
Washer (3)
Cushion (3)
Collar (3)
Braze pipe 1 at point A and I, then braze pipe 2 at
point B and H.
Pipe 2
Pipe 1
ILL00598-00
A
B
H
I
Cushions and collars are packaged in the
supplied compressor assembly.
< NOTE >
Pipe 1 and pipe 2 are packaged in the supplied
compressor assembly.
ILL00601-00
Plastic Cover MC-S
MC-R
MC-C
OLC-3
Overload
Relay
11.2 Compressor Installation