MovinCool Classic 10 Service Manual - Manual (Page 48)

Repair Section 48
9.2 Disassembly
1) Remove the drain tank.
2) Unfasten the two clips and the lower-side hook,
and then remove the front panel.
3) Take out the four (4) screws, and then remove
the cooling air duct.
4) Take out the seven (7) screws, and then remove
the service panel.
5) Remove the two (2) power supply lines from the
terminal block 1, and remove the ground wire.
I002600
Cooling Air Duct
Screws (4)
Front Panel
Drain Tank
I002601
Screws (7)
Service Panel
ILL00568-00
TB1:Terminal Block 1
Ground Wire
Power Supply
Lines (2)