MovinCool Classic 10 Service Manual - Manual (Page 59)

Repair Section 59
ILL00571-00
RB: Relay Board
TB2: Terminal Block 2
Control Box
Support
CF: Capacitor for Fan Motor CC: Capacitor for Compressor
TB1: Terminal Block 1
- Capacitor for fan motor: Remove the one (1) screw from the control box.
- Capacitor for compressor: Remove the one (1) screw from the control box.
- Terminal block 2 (signal connection): Remove the two (2) screws from the control box.
- Terminal block 1 (power connection): Remove the two (2) screws from the control box.
- Relay Board: Remove the six (6) supports from the relay board.
(3) Removal of control box
1) Take out the three (3) nuts, and then remove the
control box.
I002606
Control Box
Nuts (3)
(4) Removal of electrical parts