MovinCool Classic 10 Service Manual - Manual (Page 50)

Repair Section 50
10) Unfasten the two connectors (11-pin, 5-pin) from
the control panel.
11) Remove the wiring harness from the clamp and
board clamp.
12) Take out the seven (7) screws, and then remove
the left-side panel.
CAUTION
The screw (1*) on the front side of the left-side
panel differs from the rest. Ensure that the
correct screw is used when attaching the
left-side panel.
13) Remove the air filter from the right-side panel.
14) Take out the eleven (11) screws, and then
remove the right-side panel.
CAUTION
The screw (1*) on the front side of the right-
side panel differs from the rest. Ensure that the
correct screw is used when attaching the
right-side panel.
I001731
Board Clamp
Clamp
Connectors
Upper Panel
Control Panel
I002604
Left Side Panel
Screws (6)
Screw (1*)
I001733
Air Filter
I002358
Screws (9)
Screw (1)
Screw (1*)
Right Side Panel