MovinCool Classic 10 Service Manual - Manual (Page 64)

Repair Section 64
(1) Removal of compressor assembly
2) Remove the insulators from pipe 2 and accumulator.
1) Disconnect CC1 and CC2 wires (white) from the
capacitor for compressor in the control box.
Disconnect TBT wire (black) from the terminal block 1
in the control box.
3)
4)
Braze at point A and B.
Remove three (3) nuts and three (3) washers, and
keep them for installation, then remove the compressor.
Remove three (3) cushions and three (3) collars and
discard.
Pipe 2
Control Box
TB1:Terminal
Block 1
TBT wire
CC1 wire
CC2 wire
Insulators
Accumulator
ILL00567-00
ILL00600-00
Pipe 2
Pipe 1
ILL00598-00
ILL00599-00
A
B
Compressor
Nut (3)
Washer (3)
Cushion (3)
Collar (3)
CC:Capacitor
for Compressor
WARNING
Disconnect power supply from the unit before
performing any service. Beware that some residual
voltage may remain in the unit immediate after the
power is disconnected.