MK Products CobraTig 150 XM - Manual (Page 28)

CobraTig 150 Owner's Manual P/N 091-0417 - Page 28
Those locations with the word EMPTY above the number, indicate that
there is no weld procedure saved in that location.
Locations
In order to transmit a procedure, first locate the location number of where
the procedure is saved. Then press the applicable button to send. The
START RECEIVE button will then toggle to show STOP XMIT, prompting
the operator to cancel the transmission when pressed.
On the receiving unit, simply press the START RECEIVE button to saved
the transmitting procedure, then press the location number of where the
procedure is to be saved. If the procedure is saved to a location that is
empty, the EMPTY label will disappear once the procedure is saved.
Scroll Right
Each time this button is pressed, the locations of where each weld proce-
dure is saved or can be saved to, will move three numbers to the right.
Those locations with the word EMPTY above the number, indicate that
there is no weld procedure saved in that location.
Section 15 Setup Menu
This menu is used to set up the user’s preferences of the weld procedure
serialization, button clicks and sounds, and LCD display contrast.
Help
Press this button to read a brief description of the SETUP MENU button
descriptions and functions.
Main Menu
Press this button to change to the MAIN MENU.
Decrease S/N
This button will DECREASE the starting serial number of the next orbital
weld. The serial number is incremented before every weld, so use one
number less than actual number of next weld.
Increase S/N
This button will INCREASE the starting serial number of the next orbital
weld. The serial number is incremented before every weld, so use one
number less than actual number of next weld.