MK Products CobraTig 150 XM - Manual (Page 10)

CobraTig 150 Owner's Manual P/N 091-0417 - Page 10
Section 1 Technical Information
Line Power: 100VAC 50/60 Hz Single Phase, 15A
(+/- 10%) 120VAC 50/60 Hz Single Phase, 15A
208VAC 50/60 Hz Single or Three Phase, 30A
230VAC 50/60 Hz Single or Three Phase, 30A
Output Current: 0.1~150A (+/- 1%), Constant or Pulsed
Minimum Arc Starting: 0.5 to 25 Amps
Pulse Rate: 0.01 to 2.25 Seconds Per Pulse
Arc Voltage: 65VDC Open Circuit, up to 26 welding VDC
Loop Response: 1.5 KHz
Current Regulator Freq: 30 KHz
Motor Control: 24VDC, 2A min., DC Tachometer Feedback.
Memory Storage: 25 Weld Procedures
Section 2 Mechanical Information
Weight: 42 lbs / 19.1 Kg
Height: 14 in. / 35.6 cm
Width: 8.5 in. / 21.6 cm
Length: 19 in. / 48.3 cm
Section 3 Weldhead and Torches
For robust solutions for orbital weld applications, the CopperHeads are ideal
cost savers for sanitary and high-pressure tube systems.
The CopperHead series are our most cost effective and rugged in-place or-
bital weldheads offered in three models. The CopperHead models 5001 (1/8
- 1 inch OD), 5002 (1/4 - 2 inche OD) and 5003 (1/2 - 3 inch OD) each offer
versatility and high-output production rates.
The water-cooled, narrow profile CopperHeads are lightweight and easy to
handle for those awkward welds with limited access.
The high-output model 5000 (1/16 - 3/4 inch OD) is a robust heavy-duty
water-cooled tube and minature weld fitting in-place orbital weldhead for high
purity tube systems.
All MK weldheads can be utilized as bench mounted or remotely controlled
untis.
The models and the capacities are as follows:
MODEL CAPACITY (Max. OD)
4000 1/16” - 1/8”
5000 1/16” - 3/4”
5001 1/8” - 1”
5002 1/4” - 2”
5003 1/2” - 3”
5006 2" OD - 6" NPS
With a simple power connector pigtail (P/N 005-0619), all previously sold MK
Orbital weldheads will adapt to the CobraTig® 150 XM. You must change
the previous electrode and ground cable connectors from the push-in type to
a twist-lock type.