MK Products CobraTig 150 XM - Manual (Page 23)

CobraTig 150 Owner's Manual P/N 091-0541 - Page 23
Paper Feed
Press and hold this button down in order to feed paper through the
printer driver mechanism. This is especially useful after loading a new
roll of paper.
Printer Reset
Should the printer run out of paper either during a PRINT WELD or while
feeding, the PRINTER STATUS field will read as follows, “Error, Printer
Error.”.
Once a new roll of paper has been loaded and fed through using the
PRINTER FEED button, press the PRINTER RESET button once. This
should return the PRINTER STATUS field to read, “OK”.
To load a new roll of paper, slide printer tray straight out until it stops.
Disengage the Printer Drive Mechanism by pulling down the Drive
Latch Arm on the left side of the printer. Unroll approximately 4 to
6 inches of paper from the roll and insert between the Printer Drive
Mechanism and the bottom platen, push the paper through until it
emerges from the front panel of the printer tray.
Insert roll of paper between pins and spin backward to pull up any
extra slack in the paper. Engage the Drive Latch Arm upward to
secure the Printer Drive Mechanism.
Drive Latch Arm
Bottom Platen
Driver Mechanism