MK Products CobraTig 150 XM - Manual (Page 17)

CobraTig 150 Owner's Manual P/N 091-0541 - Page 17
From the MAIN MENU screen press this button to select orbital welding.
Once at the WELD ORBITAL screen, use the RECALL PROGRAM button
at the bottom of the screen to select from the library of customer designed
and saved procedures, or return to the MAIN MENU and use the APG (Auto
Procedure Generation) function in order to design a new weld procedure.
Use the SCROLL UP, SCROLL DOWN, ADJUST UP, and ADJUST DOWN
buttons to select and modify specific weld procedure parameters. Then
when all variables are set, press the START/STOP button to initiate the weld-
ing process.
Once at the WELD ORBITAL screen, the last orbital weld procedure is dis-
played from memory. This is the default procedure and ready to weld. If a
different weld procedure is desired, it can either be recalled from memory or,
developed using the Auto Program Generator (APG).
Start/Stop
Pressing this button will start the prepurge gas flowing and start the weld-
ing procedure.
Main Menu
Press this button to return to the MAIN MENU.
Print Weld
Press the PRINT WELD button to obtain a printout of the last weld proce-
dure parameters and the wave form strip chart of the completed weld.
This will give a weld procedure printout, first showing the description of
the procedure, followed by the all the welding parameters, then by Limit
and Deviation parameters, then by the actual strip chart of the weld cur-
rent, arc voltage and motor speed.
Scroll Up
Press this button in order to scroll and select the highlighted field from
one DEMAND parameter up to the next.
Adjust Up
After the SCROLL UP or SCROLL DOWN buttons have been used to
select a parameter to be modified, press the ADJUST UP button to in-
crease the numerical value of that parameter.
As this button is pressed for each parameter a vertical bar graph shows
the increasing value, both numerically and in height of the bar graph.
For most parameters, a maximum value is obtained once the vertical bar